User's Manual

8
FS-lT4S
Digital proportional radio control system
2.3.3 Status Indicator
The status indicator is used to indicate the power and working status of the transmitter.
□
Off: the transmitter is powered off.
□
Blue light: the transmitter is on and working.
□
Flashing: the transmitter is binding.
2.3.4 Trims
There are 4 trims affecting surface functionality, one for throttle, steering, reverse and . Each time a trim is
toggled, the trim will move one step. It is possible to make quicker trim adjustments by holding the trim in
the desired direction. When the trim position reaches the middle, the transmitter beeps in a higher tone.
2.4 Receiver Overview
2.4.1 Receiver Antenna
Attention
• For best signal quality, ensure that the receiver is mounted away from motors
or metal parts. Also make sure that the antennas are mounted at a 90 degree
angle to each other.
2.4.2 Status Indicator
The status indicator is used to indicate the power status of the receiver.
□
Off: the power is not connected.
□
Lit in red: the receiver is on and working.
□
Flashing quickly: the receiver is binding.
□
Flashing slowly: the bound transmitter is off.
2.4.3 Connectors
The connectors are used to connect the parts of model and the receiver.
□
CH1 to CH4 connectors are used to connect the servos, power or other parts.
□
B/PPM connector is used to connect the bind cable for binding.