User's Manual

8
4.
OperationInstructions
After setting up, follow the instructions below to operate the system.
4.1PowerOn
Follow the steps below to turn on the transmitter:
1. Make sure that：
• The battery is fully charged and installed correctly.
• The receiver is installed correctly and powered down.
2. Hold the power button until the screen turns on.
3. Connect the power supply to the receiver.
Note • Operatewithcautioninordertoavoiddamageorinjury.
Note
• Makesurethatthethrottleisatitslowestpositionandtheswitchesaresettotheirup
position.
4.2Binding
The transmitter and receiver have been pre-bound before delivery.
1. Connect the bind cable to the receiver's B/VCC port.
2. Connect power to any other port.
3. Select "Bind With A Receiver" in the transmitter's RX Setup menu.
4. Once binding is complete the transmitter will exit bind mode. Remove the power and bind cable from the
receiver then apply power to the B/VCC port.
5. Check to make sure everything functions as expected. If not repeat the steps above.
If you are using another transmitter or receiver, follow the steps below to bind the transmitter and receiver:
4.4PowerO󽗈
Danger
• Makesuretodisconnectthereceiverpowerbeforeturningo󽗈thetransmitter.Failure
todosomayleadtodamageorseriousinjury.
Follow the steps below to turn o󽗈 the system:
1. Disconnect the receiver power.
2. Hold the transmitters power button until the screen turns o󽗈.
4.3TransmitterLEDIndicator
This LED has six colors, green, blue, cyan, red, yellow, white and o󽗈 which can be set according to user preference.
To change the LED color see the LED Strip section of this user manual.