Instruction Manual

ManualsBrandsFLYSKY ManualsElectronicsMini 4-channel receiver

GMr

接收机 Receiver

http://www.flysky-cn.com

发射机在更新完后，如无法与接收机对码，需强制更新接

手机。

1. 按住对码键同时给接收机上电，长按 10S, 接收机进入强

制更新状态，此时 LED 三闪一灭；

2. 在发射机端选择接收机更新并进入更新状态，更新过程

中 LED 三闪一灭；

3. 当发射机端显示 100% 即为更新成功，此时 LED 慢闪。

强制更新

Forced update

失控保护功能用于在接收机失去信号不受控制后，保护模型及人员安

全。

请在发射机端设置失控保护，设置方法请参照对应的发射机说明书。

失控保护

Failsafe

兼容性

Compatibility

该接收机兼容 PL18、NB4 和 NB4 Lite 等 AFHDS 3 协议发射机

注意事项：

• 使用前必须确保本产品与模型安装正确，否则可能导致模型发生严重损坏。

• 关闭时，请务必先关闭接收机电源，然后关闭发射机。如果关闭发射机电源时接收机仍然在工作，将有可能导致遥控设备失控或

者引擎继续工作而引发事故。

• 确保接收机安装在远离电机，电子调速器或电子噪声过多的区域。

• 接收机天线需远离导电材料，例如金属棒和碳物质。为了避免影响正常工作，请确保接收机天线和导电材料之间至少有 1 厘米以

上的距离。

Attention:

• Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.

• Make sure the receiver's battery is disconnected before turning o󽗈 the transmitter, failure to do so may lead to unintended

operation or loss of control.

• Make sure the receiver is mounted away from motors, electronic speed controllers or any device that emits excessive

electrical noise.

• Keep the receiver's antenna at least 1cm away from conductive materials such as carbon or metal.

If after an update the transmitter is unable to connect or bind to the receiver, it is

necessary to put the receiver into forced update mode.

1.Press and hold the Bind button while powering on the receiver simultaneously,

press and hold for 10 seconds to enter forced update mode, during this time the

LED 󽗊ashes three times and o󽗈 one time;

2. Select the receiver to update on the transmitter side to enter the update

mode;the LED 󽗊ashes three times and o󽗈 one time during the updating process;

3. updating is successful when the receiver status indicator 󽗊ashes slowly.

This function protects the user by preventing the model from

behaving unexpectedly if signal is lost.

Make sure to setup the failsafe function on the transmitter. For more

information on setting up the failsafe refer to the transmitter's user

manual.

The receiver is compatible with PL18/NB4 and NB4 Lite all of

transmitters which with AFHDS 3 protocol .