Manual

Operating Manual Flytec 6020
2.6.4.1 Waypoints - alter, delete or insert
W
aypoints
--------------
Flytec
Fiesch
In this position of Setup-Menu the waypoints may be managed. Waypoints may also be set
comfortably on the PC by use of the „Flychart 4.52“ PC-Software and be transferred
via the PC-interface to the instrument.
Using Menu
⇒ Waypoints prompts a list with the waypoints
stored in memory. If this list contains more than the visible 6
waypoints, a down arrow Ð at the right lower edge of the list
warns that more pages are to follow. To scroll down page by
page, press the ► key, now WP 7 … 12 are displayed etc.
Using the keys ▲ and ▼ it is possible to select an
individual WP for editing after pressing the
OK
key.
Flims, Station
Cassons Grat
---------------⇓
Waypoint 2
Fiesch
Alti 1048 m
N 46’ 24.446
The 1st letter of the WP name will blink. Again
with the ▲ and ▼ keys the required letter is selected; there are
numbers, letters, as well as a set of special characters to
choose from. By pressing the ► key one moves forward to the
E 008’ 08.264
----------------
Ins Del
WP WP
next letter etc. With the
F1
key one can shift between capitals
and minuscule. With the
F2
key one single character is deleted
(Rub out). You can enter a maximum of 16 numeric.
Once the name has been entered completely, confirm by pressing
OK
. Now the waypoint
altitude will blink, requiring any alterations. With the ▲▼ keys the altitude value is entered
and confirmed by pressing
OK
. Now the position of WP is next. At first the latitude is entered
in degrees and confirmed with
OK
, after that the minutes, confirmed by
OK
and then the
decimals of the minutes. The same procedure is applied for the longitude. Holding the key
down for a longer moment, changes the values to be set faster.
Delete Waypoints:
The selection of WP’s to be deleted is effected with the ▲ and ▼ keys.
Pressing the
F2
key (Del WP) enables the deleting function, for data safety the 6020-GPS
is asking again: “Delete Waypoint?”. The reply “Yes” or “No” is at choice, but it is also
possible to discontinue the deleting procedure by use of the
Page/ESC
On/Off
key and return to one level
before.
Insert Waypoints:
Pressing the
F1
key (Ins WP) enables this function. Entering waypoint names, altitude and
position is operated by following the same scheme as described above. After confirming all
entries with the
OK
key, the new WP is inserted in alphabetical order to the list. In total up to
200 WP can be saved in the 6020-GPS instrument.
Caution: after inserting the new waypoints, (for ex. entry of a new Route) these can be used
only, if in between one has switched back to the normal flight mode by pressing Esc.
Furthermore, the Route into which the new waypoint should be inserted must not be active.
Therefore, first change into route selection by prolonged pressing of the
key and
deactivate the Route with the help of the
F2
key (Cancel Route).
The more waypoints there are in memory, the more slowly becomes the navigation in the
Main Setup Menu, because the list is always tabulated again in the background.
2.6.4.2 Display of actual Coordinate
If the 6020-GPS receives satellites by GPS-Receiver, the actual position is displayed
by short pressing of the
i
key in the instrument’s information field. After 20 sec. the
previous display screen will automatically reappear. This function is useful in relaying
- 21 -