User's Manual Part 2

J2 680 System Manual
Version 1.0 May 11, 2012
40
Boot Settings
If more than one bootable device is in the system the boot order can be set in this menu.
If a bootable USB storage device is plugged in at boot up the 680 will boot from that
device by default. If this is not desired the boot order can be changed here. A list of
detected drives will be displayed with the current boot order.
Boot Settings Screen
Display OEM Logo
The BIOS can display two types of OEM logos on boot up. The default is a small J2 logo
in the upper left hand corner. With this setting BIOS POST test messages can be seen
during boot up. The second type which is enabled by this entry is a full screen J2 logo.
When this logo is selected the BIOS POST messages cannot be seen. The BIOS setup can
still be entered by typing the DEL key a few seconds after the logo appears.
Customer logos can replace the J2 logos when required. Please contact J2 regarding this,
if required.