User's Manual

7
2. Place the system face down to access the bottom of the stand.
3. Thread the power adapter cable through the hole of the stand as shown in the picture.
4. Find the power connector on the right of the I/O panel (refer to chapter 2-4 c.) and
connect the power adapter to the DC-IN connector.
5. Finally arrange and x the cable by using the hook as shown in the picture.
Warning:
• Please follow the direction to plug the adapter and make sure it is fully connected
into the I/O port.
• When attaching or detaching the cable, do so by holding the connector, not the
cable itself.
• DO NOT pull or rotate the cable which may cause damage to the tting.