User's Manual

15
3 Getting Started
3-1 Power On/Off the System
1. Press the power button for 2 seconds to
turn on the system and press it for 6
seconds to turn off the system.
Note: For best touch performance, remove
the protective plastic overlay from the touch
screen by peeling it away from one of the
corners. Be sure to use a soft pointing
device or finger tip to avoid scratching the
screen during normal use.
3-2 Installing the Peripheral Kits
1. Remove the dummy cover first. Remove the rubber pads (x2) and screws (x2)to release
the top cover of the MSR module.
2. Connect the cable to the connector on
the system side. Then position the MSR
module over the system as shown and
fasten with the screws (x2). Finally place
the top cover of the MSR module back.
NOTE: The variety of peripheral kits like
RFID/Fingerprint and iButton all follow the
same installation method.