Data Sheet

environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
This module is intended for OEM integrators under the following conditions:
1. This module is certified pursuant to two Part 15 rules sections(15.407, 15.247).
2. This module has been approved to operate with the antenna types listed below, with
the maximum permissible gain indicated.
Frequency Band
Antenna Type
Model Number
Gain(dBi)
2400-2483.5MHz PCB Antenna A9703688-D 1.39
5150-5850MHz PCB Antenna A9703688-D 3.34
3. Label and compliance information
Label of the end product:
The host product must be labeled in a visible area with the following " Contains FCC ID:
XHM-AP6255D42".
The end product shall bear the following 15.19 statement: This device complies with part
15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
If the labelling area is considered too small and therefore it is impractical (smaller than the palm of the hand) to display the compliance
statement, then the statement may be placed in the user manual or product packaging.
4. Information on test modes and additional testing requirements
This module is restricted to integration into hosts for indoor use only.
This module has been approved under stand-alone configuration.
OEM integrator has be limited the operation channels in channel 1-11 for 2.4GHz band.
The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
The information on how to configure test modes for host product evaluation for different
operational conditions for a stand-alone modular transmitter in a host, , versus with
multiple, simultaneously transmitting modules or other transmitters in a host can be found
at KDB Publication 996369 D04.
5. Additional testing, Part 15 Subpart B disclaimer
Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment
authorizations (e.g. SDoC) of the host product to be addressed by the
integrator/manufacturer.
This module is only FCC authorized for the specific rule parts 15.247, 15.407 listed on
the grant, and the host product manufacturer is responsible for compliance to any other
FCC rules that apply to the host product as being Part 15 Subpart B compliant.
6. The user manual of the end product should include:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
The antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This device is restricted to indoor use.
The antenna(s) used for this transmitter must not transmit simultaneously with any other
antenna or transmitter.
Professional installation
Section 15.204(b) states that an approved "transmission system" must always be marketed as a complete system
including the antenna.