User Manual

13
❑
1. Connect the wing lighting wires and the aileron servo
wires to the lighting aileron and  ap wiring harnesses
coming from the receiver.
❑
2. Turn on the transmitter and install and connect the
battery. Then install and secure the hatch.
❑
3. Move the dial or switch on your transmitter that
controls the  aps to the “up” position, rotating the  ap
servo arm clockwise. Remove the screw in the  ap servo
arm, wet the threads with threadlocker, and then reinstall
and tighten the screw so the  aps will be in their fully
retracted (“up”) position.
❑
4. With the system still on, make sure the ailerons are
centered and aligned with the wing tips. If necessary, apply a
few clicks of aileron trim to get the ailerons centered. If more
than a few clicks of trim are required, or if you cannot get
both ailerons neutralized, a small screwdriver may be used
to pop off one or both aileron servo covers to access the
pushrods. Adjust the pushrods in the connectors to get the
ailerons centered. When  nished, replace the cover, press
into position, and hold in place with tape or a dab of glue.