User Manual

❏

6. Insert the 3 x 25mm machine screw into the hole in the

bottom of the fuselage. Thread the 3 x 25mm machine screw

through the horizontal stabilizer and into the bottom of the

vertical ﬁ n.

Connect the Rudder and

Elevator Controls

❏

1. Use needle-nose pliers to unsnap the 90° pushrod

connector from the rudder pushrod.

❏

2. Insert the pushrod into the inner hole of the rudder

control horn.

❏

3. Re-install the 90° pushrod connector on the pushrod.

Use needle-nose pliers to snap the 90° pushrod connector

onto the wire.

❏

4. Repeat the process to install the elevator pushrod in the

outer hole of the elevator control horn.