Fireplace Manufacturers Inc Log Splitter User Manual

ManualsBrandsFMI ManualsLog SplitterREPLACEMENT LOG SET BTB18

Figure 1 - Removing Log Set

Figure 2 - Installing Replacement Log Set

Save these instructions for future reference

REPLACEMENT LOG SET

INSTALLATION INSTRUCTIONS

FOR BTB18, BTB24, PDG18 AND PDG24 GAS LOG HEATERS

WARNING: If log set has been in use, make sure

control knob is in the OFF position, unit is cold and

gas has been turned off.

Part No. Description Qty.

111835-01

111834-01

111827-01

111802-01

111817-08

111824-01

Your replacement kit will contain only one log set assembly depend-

ing on your model. If there is a problem with your replacement log

set contact the authorized dealer where you bought the set or FMI

PRODUCTS, LLC at 1-866-4537.

Items Needed for Installation:

• 5/16'' Hex Socket Wrench or Nut Driver

• Phillips Screwdriver

• 5/8'' Wrench or Adjustable Wrench

1. Remove six screws from sides of log set assembly (three on

each side). Remove log set assembly (see Figure 1). Do not

pull on log assembly to remove. Work log set off chassis by

manipulating metal base.

2. 18'' models only:Disconnectexiblegaslinefromvalveand

burner(seeFigure1).Discardexline.

Replacement Log Set 18'' - BTB18

Replacement Log Set 18'' - PDG18

Replacement Log Set 24'' - BTB24

Replacement Log Set 24'' - PDG24

Flex Tube

Compression Nut/Sleeve

24" Set

18" Set

Bracket

Chassis

Disconnect

Flexible Gas Line

24" Set

18" Set

3. Place new log set assembly over chassis and align holes on

bracket with holes on chassis (see Figure 2).

4. Replace six screws removed in step 1.

Summary of content (2 pages)

PAGE 1
REPLACEMENT LOG SET INSTALLATION INSTRUCTIONS FOR BTB18, BTB24, PDG18 AND PDG24 GAS LOG HEATERS WARNING: If log set has been in use, make sure control knob is in the OFF position, unit is cold and gas has been turned off. Part No. 111835-01 111834-01 111827-01 111802-01 111817-08 111824-01 Description Replacement Log Set 18'' - BTB18 Replacement Log Set 18'' - PDG18 Replacement Log Set 24'' - BTB24 Replacement Log Set 24'' - PDG24 Flex Tube Compression Nut/Sleeve 3.
PAGE 2
5. 18'' Models Only: To assemble nex flex line, insert flex tube into end of compression nut with small opening. Place sleeve over end of flex tube and into compression nut. Repeat for other end. Attach new flexible gas line to valve and burner routed through grate as shown in Figure 3. It is very important that you route the flex line through the back leg on the grate. It could interfere with placement in fireplace if routed around leg.