500MM P-47 RAZORBACK REALISTIC RETRACT & FLAPS INSTALLED RIGID STRONG DURABLE EPO STABLE SMOOTH FLYING PERFORMANCE FMSMODEL.
Table of Contents Introductions ··························································································································3 Contents of Kit ························································································································4 Assembling the Plane ··············································································································5 Battery and radio installation ······················································
Wingspan: 1500mm (59.0in) Overall Length: 1270mm (50.0in) Flying Weight: Around 3700g (59.3oz) Motor Size: Brushless 4258-KV460 Wing Load: 92.5 g/dm² (0.21oz/in²) Wing Area: 40.0 dm² (620 sq.in) ESC: 70A Servo: 17g metal digital x 6, 9g metal digital x 3 Contents of Kit Before assembly, please inspect the contents of the kit. The photo below details the contents of the kit and labels.
Horizontal Tail Installation 1. Slide the horizontal tail tube into the hole in the rear of the fuselage. 2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the control horn faces down. 3. Secure the two horizontal tail pieces in place using the 4 included screws. KA3.0×15 fig1 fig2 4.Connect the rudder control surface to the horizon vertical tail as shown. 5.Attach the ball link to the elevator control horn.
Main Wing Installation 1. Slide two tubes into the fuselage then install both wings over the wing tube and into the wing slot of the fuselage. Notice: The connectors on both side should be attached precisely and firmly. fig5 2. Secure the wings on the fuselage using 4 screws inside the top of fuselage.
Drop Tank, Rocket Tubes, Bomb, Machine Guns and Antenna Installation 1.Slide the Rocket Tubes and drop tank into the rails. 2.Carefully apply foam safe CA to the base and side of the Bombs pocket and place the bombs into the pocket. 3.Carefully apply foam safe CA to the base and side of the machine guns pocket and place the machine guns into the pocket. 4.Insert the air speed head into the place as picture shows . 5.Apply foam safe CA to the Antenna and place the antenna into the hole as picture shows .
Battery and radio installation 1. Apply the hook tape to the cable end of the battery (fig8). 2. Slide the battery into the battery hatch with the power supply cable toward the rear end of the plane and the hook tape facing the bottom of the battery hatch. Note: You may need to relocate the battery position to achieve the correct CG for your model.
Get your model ready to fly Important ESC and model information 1. The ESC included with the model has a safe start. If the motor battery is connected to the ESC and the throttle stick is not in the low throttle or off position, the motor will not start until the throttle stick is moved to the low throttle or off position. Once the throttle stick is moved to the low throttle or off position, the motor will emit a series of beeps.
Check the control throws The suggested control throw setting for FMS MODEL are as follows (dual rate setting): 18 16 30 14 12 22 Tips: On first flight, fly the model in low rate. The first time you use high rates, be sure to fly at low to medium speeds. High rate, as listed, is only for EXTREME maneuvering. Check the motor rotating direction The motor should rotate clockwise when viewing the plane from the rear.
Install the propeller and spinner Assemble the spinner and propeller as shown below. a b c d e f Check the C.G. (Center of Gravity) When balancing your model, adjust the motor battery as necessary so the model is level or slightly nose down. This is the correct balance point for your model. After the first flights, the CG position can be adjusted for your personal preference. 1.
Before flying the model Find a suitable flying site Find a flying site clear of buildings, trees, power lines and other obstructions. Until you know how much area will be required and have mastered flying your plane in confined spaces, choose a site which is at least the size of two to three football fields - a flying field specifically for R/C planes is best. Never fly near people especially children, who can wander unpredictably.
Flying your model Take off While applying power, slowly steer to keep the model straight. The model should accelerate quickly. As the model gains flight speed you will want to climb at a steady and even rate. P-47 will climb out at a nice angle of attack (AOA). Flying Always choose a wide-open space for flying your plane. It is ideal for you to fly at a sanctioned flying field. If you are not flying at an approved site always avoid flying near houses, trees, wires and buildings.
Troubleshooting 15
Spare parts list content FMSPT101 FMSPT102 FMSPT103 FMSPT104 FMSPT105 FMSPT106 FMSPT107 FMSPT108 FMSPT109 FMSPT110 FMSPT111 FMSPT112 FMSPT113 FMSPT115 FMSPT116 FMSPT117 FMSPT118 FMSPT119 FMSPT120 FMSPT121 FMSPT122 FMSPROP004 FMSBM003 FMSDJ014 FMSDZ020 PRKV460 PRESC003 FMSSER9MGDP FMSSER9MGDR FMSSER17MGD FMSRE027 FMSRE028 FMSSEQ6S FMSCON003 Fuselage Main Wing Set Horizontal Stabilizer Cowl Spinner Canopy Hatch Plastic Scale Cockpit Bomb Oil Tank Rockets Antenna Main Landing Gear Set Main Landing Gear System
ESC instruction 17
