Owner’s Manual 2020

46
To install a different optic or slide
cap:
1. Loosen and remove the two
screws holding the optic or slide
cap to the slide of the pistol by
turning the screws counter
clock-wise (Figure 66).
2. Remove the optic or slide cap,
MRD plate and o-ring
(Figure 67 & 68).
3. Inspect and clean the mounting surface on the top of the slide.
4. Select the appropriate MRD plate and screws to match the optic to be
installed. Note: A table with MRD plate information can be found later
in this section.
5. Remove all lubrication from the mounting screws and the mounting
screw holes that will be used to install the selected optic or slide cap.
6. Place the o-ring in the recess in the MRD plate cut in the top of the
slide (Figure 69.).
FIGURE 67
FIGURE 68
FIGURE 66