Owner’s Manual 2020

57
8. Clean all of the parts of the pistol and magazine that are accessible
using a soft cloth or rag dampened with a lightweight gun oil or
multipurpose lubricant and nylon brush, if needed, to remove the
fouling and debris accumulated during firing.
9. Check the disassembled parts of the pistol for signs of wear and/or
damage. In case of doubt about the condition of a part, consult an FN
authorized individual.
10. Using a soft cloth moistened with lightweight gun oil, lightly apply the
lubricant to all the external surfaces of the metal parts to increase
corrosion resistance.
11. Apply a drop of lubricant to the locations shown in Figure 61 on
page 49.
12. Reassemble the pistol as described in Section 12.
13. Clean the outside of the pistol in order to remove dirt, fingerprints and
excess lubricant.
NOTE: If the pistol requires additional cleaning due to exposure to adverse
conditions, it should be serviced by an FN authorized individual or service
center.