Manual

28
3. Lock the buttstock by applying slight pressure to the buttstock,
ensuring the buttstock locking notch engages the shell deflector
(Figure 16, page 27).
17.2. UNFOLDING THE BUTTSTOCK MODULE
1. Firmly grasp buttstock and unlock it from the shell deflector by pulling
down and away from the receiver (Figure 17, page 27).
2. Fold the buttstock to the left with enough force to ensure a positive
lock into the backplate.
3. Inspect buttstock to ensure a positive lock.
17.3. ADJUSTING LENGTH OF PULL
To adjust the length of pull (LOP), press the LOP adjustment lock
(Figure 18) and push or pull buttstock module to change LOP as
desired (Figure 19).
Adjustments are numbered 1 through 6. Each adjustment is equal to .50"
for a total of 2.50" of LOP adjustment. After adjusting LOP, check to see
that the LOP adjustment lock is fully engaged by pulling or pushing on the
rear of the stock.
17.4. ADJUSTING THE CHEEK REST HEIGHT
To adjust the cheek rest height, press the cheek rest button (Figure 20) and
push or pull the cheek rest down or up to the desired position (Figure 21).
Raising the cheek rest will provide an additional 0.51" of comb height.
After adjusting the cheek rest to the desired setting, check to see that the
cheek rest button is fully engaged by pulling up or pushing down on the
cheek rest.
18. SIGHTS
BEFORE ADJUSTING THE SIGHTS, PLACE THE “SAFETY”
SELECTOR IN THE ON SAFE POSITION. REMOVE THE
MAGAZINE, LOCK OPEN THE BOLT AS EXPLAINED IN
SECTION 10.2. AND MAKE CERTAIN THE CHAMBER IS
COMPLETELY UNLOADED. KEEP THE MUZZLE POINTED IN A
SAFE DIRECTION. FAILURE TO FOLLOW THESE WARNINGS
COULD RESULT IN SERIOUS INJURY OR DEATH.
18.1. EXPLANATION OF THE SCAR 16S SIGHT SYSTEM
SCAR rifles include rear and front iron sights that are fully adjustable for
both windage and elevation.
FIGURE 20
Press and hold the cheek rest button.
FIGURE 21
Move the cheek rest to the desired height.
FIGURE 18
Press and hold the LOP Adjustment Button.
FIGURE 19
Move the buttstock to the desired length.
29