Manual

35
2. Push in on the takedown pin from
the left side (Figure 26) and pull it
out to the right until it stops
(Figure 27).
IMPORTANT: The takedown pin is
captive and cannot be removed
completely from the trigger module.
3. Push the trigger module forward,
releasing it from the from the
backplate (Figure 28).
4. Pull down to remove the trigger
module from the receiver (Figure 29).
19.2. REMOVAL OF THE BUTTSTOCK MODULE
1. Remove the magazine and make certain the rifle is completely
unloaded and the “safety” selector is in the on safe position as
explained in Section 9.
2. Remove the trigger module as explained in Section 19.1.
3. Push the buttstock module downward and off of the receiver assembly
backplate (Figure 30).
19.3. REMOVAL OF THE MOVING PARTS ASSEMBLY
1. Remove the magazine and make certain the rifle is completely
unloaded and the “safety” selector is in the on safe position as
explained in Section 9.
2. Remove the trigger module as explained in Section 19.1. and the
Buttstock Module as explained in Section 19.2.
Notice! THE FOLLOWING DISASSEMBLY PROCEDURES ARE
DESIGNED TO BE PERFORMED WITH FINGER PRESSURE
ONLY AND NO TOOLS ARE TO BE USED. IF YOU CANNOT
COMPLETE THE DISASSEMBLY PROCEDURES DESCRIBED
WITHOUT THE USE OF TOOLS STOP AND CONTACT FNH USA
SERVICE FACILITY IN ARNOLD, MISSOURI.
19.1. REMOVAL OF THE TRIGGER MODULE
1. Remove the magazine and make certain the rifle is completely
unloaded and the “safety” selector is in the on safe position as
explained in Section 9.
34
FIGURE 30
Push the buttstock module off of the
receiver assembly.
FIGURE 26
Push in on the takedown pin from the left side.
FIGURE 27
Pull the takedown pin to the right until it stops.
FIGURE 28
Push the trigger module forward.
FIGURE 29
Pull the trigger module down to remove it.