Manual

36 37
4. Remove moving parts assembly as explained in Section 19.3.
5. Push the firing pin retaining pin out of the bolt carrier from right to
left by using the small end of the charging handle (Figure 33).
6. Remove the firing pin from the rear of the bolt carrier (Figure 34).
7. Remove the bolt cam pin from the left side of the bolt (Figure 35).
8. Remove the bolt from the front of the bolt carrier (Figure 36).
3. Pull the charging handle rearward and apply downward pressure to the
guide rod retaining plate (Figure 31). Then pull the charging handle all
the way to the rear.
4. With the moving parts assembly
to the rear, pull out on the charging handle and remove it from the
assembly (Figure 32).
5. Remove the return spring assembly by pulling it out towards the rear.
6. With the charging handle and return spring assembly removed, the
entire moving parts assembly can be removed from the rear of the
receiver by placing your hand at the rear of the receiver and
raising the muzzle, allowing the moving parts assembly to slide out
into your hand.
19.4. DISASSEMBLY OF THE MOVING PARTS ASSEMBLY
1. Remove the magazine and make certain the rifle is completely
unloaded and the “safety” selector is in the on safe position as
explained in Section 9.
2. Remove the trigger module as explained in Section 19.1.
3. Remove the buttstock module as explained in Section 19.2.
Remove the bolt.
FIGURE 36FIGURE 35
Remove the bolt cam pin.
FIGURE 32
Remove the charging handle.
FIGURE 34
Remove the firing pin.
FIGURE 33
Use the charging handle to remove the firing
pin retaining pin.
FIGURE 31
Pull down on the retaining plate and pull back
on the charging handle.