Manual

46 47
3. Slide the moving parts assembly back into the receiver until the
charging handle slot on the bolt carrier is aligned with the charging
handle slot in the receiver frame.
4. Insert the charging handle into the left or right side of the receiver
(Figure 45, page 45). (Generally into the left side for right-handed
operators and into the right side for left-handed operators.)
5. Using the charging handle, slide the moving parts assembly all the way
forward in the receiver. You may need to apply downward pressure on top
of the guide rod retaining plate to clear the backplate in order to slide
the moving parts assembly all the way forward.
IMPORTANT: Be sure that the guide rod retaining plate is fully seated into the
backplate or it will prevent the buttstock from sliding into place.
21.4. INSTALLATION OF THE BUTTSTOCK MODULE
1. Install the buttstock module by pressing in on the retaining plate and
sliding the buttstock module on the backplate until seated (Figure 46).
21.5. INSTALLATION OF THE TRIGGER MODULE
1. Ensure that the takedown pin is pushed completely to the right of the
trigger module (Figure 47).
2. Ensure that the hammer is cocked prior to re-installing the trigger
module. If the hammer is not cocked (Figure 48), press it down into the
cocked position for assembly (Figure 49).
3. Place the trigger module into position, ensuring the rear extrusion
engages the notch on the backplate at a slight angle (Figure 50).
4. Carefully rotate the trigger module into the receiver frame, pushing
it to the rear (Figure 51).
FIGURE 48
The hammer shown in the decocked position.
FIGURE 49
Cock the hammer by rotating to the rear.
FIGURE 50
Insert the trigger module rear first into
the receiver.
FIGURE 51
Raise the front of the trigger module into
the receiver and push it rearward.
FIGURE 46
Apply finger pressure to the retaining plate
and slide the buttstock module into place.
FIGURE 47
Move the takedown pin to the right side of
the housing.