Manual

48 49
5. Ensure the trigger module is fully
seated to the rear before pushing
the takedown pin to the left and
securing the trigger module to the
receiver assembly (Figure 52).
Your firearm is now fully assembled.
Immediately confirm that the “safety”
selector is in the on safe position. Take
time to wipe down and clean all
external surfaces as explained under
“Cleaning and Maintenance
Suggestions.” Perform the function check as explained in Section 21.6.
21.6. FUNCTION CHECK
With the rifle assembled, perform a function check to ensure proper
re-assembly.
1. Operate the charging handle, making certain the bolt assembly
moves freely.
2. Operate the “safety” selector, making certain that the “safety” selector
moves between on safe and off safe freely.
3. Place the “safety” selector in the on safe position and properly store
the rifle.
22. TAKING CARE OF THE RIFLE
Notice! YOUR RIFLE SHOULD BE INSPECTED EVERY
5000 ROUNDS AND/OR ONCE A YEAR BY A QUALIFIED
GUNSMITH OR THE FNH USA PRODUCT SERVICE CENTER
BECAUSE DAMAGE, WEAR AND CORROSION ARE NOT
ALWAYS VISIBLE FROM THE OUTSIDE. LAW ENFORCEMENT
AND MILITARY PERSONNEL SHOULD CONTACT THEIR
DEPARTMENTAL ARMORER WHO WILL INSPECT THE RIFLE
ON A YEARLY BASIS.
Notice! IF THE OPERATION OF THE RIFLE SEEMS
ABNORMAL, REPORT IT TO YOUR DEALER OR
DEPARTMENTAL ARMORER IMMEDIATELY.
• Always keep the rifle in immaculate condition and good working order.
• Always clean and lubricate the rifle after use.
• Regularly inspect the rifle, its parts and accessories.
23. SERVICE POLICY
If you have any questions about this owner’s manual or other
FNH USA products, contact:
FNH USA, LLC
Commercial and Law Enforcement Sales
Phone [phone], extension 122
Or visit us online at www.fnhusa.com
IF YOU DO NOT UNDERSTAND THE INSTRUCTIONS FOR OPERATING YOUR
FNH USA FIREARM, IT IS YOUR RESPONSIBILITY TO CONTACT THE FNH USA
PRODUCT SERVICE CENTER AT [phone] BEFORE USING THE FIREARM.
This owner’s manual should always accompany this rifle and be transferred
with it upon any change of ownership.
FNH USA products are serviced by the FNH USA Product Service Center in
Arnold, Missouri.
Please call [phone] to discuss any product repair requirements.
Shipping Address:
FNH USA Product Service Center
3005 Arnold Tenbrook Road
Arnold, MO 63010-4728
FIGURE 52
Press the takedown pin into position.