Addendum 2015

3
Figure 2
Figure 3
Drift on sight base
SLP Competition Rear Sight
The rear sight is adjusted for elevation using the two
small screws on the rear of the sight. Loosen them
slightly and move the sight blade up or down to adjust
the point of impact (Figure 2). Move the blade up to
move the point of impact up. Move the blade down to
lower the point of impact. Snug the screws after
making adjustments.
Note: The rear sight of the SLP Competition is
silver soldered in place. DO NOT attempt to adjust
the rear sight for windage by drifting the sight in
its dovetail. Damage to the sight and barrel may
result.
SLP Competition Front Sight
Windage adjustment is accomplished by drifting the
front sight in its dovetail. Carefully tap the sight with a
hammer using a non-marring drift punch against the
sight base (Figure 3). Drift the sight to the left to move
point of impact to the right. Drift the sight to the right to
move the point of impact to the left.
Note: Be careful to fully support the barrel at the
muzzle when drifting the front sight. Avoid
impacting the fiber-optic tube when drifting it.
Damage to the sight and barrel may result.