Manual

32 33
16. TRIGGER ADJUSTMENT
Notice! ATTEMPTING TO ADJUST THE TRIGGER MAY
AFFECT THE STOCK BEDDING AND AFFECT THE ACCURACY
WHEN THE BARRELLED ACTION IS REMOVED FROM
AND REINSTALLED INTO THE STOCK. TRIGGER
ADJUSTMENTS SHOULD BE PERFORMED BY AN
FNH USA CERTIFIED ARMORER.
16.1. TWO-LEVER TRIGGER
SPR rifles utilize a two-lever trigger design that is pre-set at the factory for
pull weight. The trigger pull weight is adjustable within a range of 3½-7.0
pounds. Though trigger adjustments should be unnecessary, the trigger pull
weight can be tuned to your specifications.
16.2. TACTICAL SPORT TRIGGER
The Tactical Sport Trigger on the TSR XP and TSR XP USA is pre-set at
the factory. The trigger pull weight is pre-set at approximately 3¾ pounds
and can be adjusted within a range of 3 to 5 pounds. Though trigger
adjustments should be unnecessary, the trigger pull weight and overtravel
can be tuned to your specifications.
17. STOCK ADJUSTMENT
BEFORE PERFORMING STOCK ADJUSTMENT PROCEDURES
OPEN THE ACTION AND MAKE CERTAIN YOUR RIFLE IS
COMPLETELY UNLOADED. KEEP THE MUZZLE POINTED IN A
SAFE DIRECTION. FAILURE TO FOLLOW THESE WARNINGS
COULD RESULT IN SERIOUS INJURY OR DEATH.
Some FNH USA bolt-action rifles feature a McMillan
™
stock that is
adjustable for length of pull and comb height (Figure 27). The comb can
be adjusted over a range of 1¼", from ¼" below to 1" above the bore line.
Length of pull can be adjusted over a range of 1½", from 12¾" to 14¼".
15.2. UNLOADING THE DETACHABLE BOX MAGAZINE (DBM)
1. Place the “safety” in the intermediate position.
2. Open the bolt, extracting the cartridge in the chamber. Leave the
bolt open.
3. Depress the magazine release and remove the magazine from the rifle.
4. Unload the magazine by sliding the cartridges forward and out of the
magazine one at a time.
15.3. UNLOADING THE TACTICAL BOX MAGAZINE (TBM)
1. Place the “safety” in the intermediate position.
2. Open the bolt, extracting the cartridge in the chamber. Leave the bolt open.
3. Depress either magazine release button and remove the magazine
from the rifle.
4. Unload the magazine by sliding the cartridges forward and out of the
magazine one at a time.
15.4. UNLOADING BY CYCLING THE ACTION
1. Place the safety in the intermediate position.
2. With the rifle pointed in a safe direction and your finger off the
trigger, cycle the bolt, extracting and ejecting each loaded cartridge
from the chamber. Work the bolt very slowly in order to easily capture
the loaded cartridges with your free hand as they are ejected. Do not
eject them onto the ground. This risks damaging them and affecting
their accuracy.