Owner’s Manual 2016

. MOUNTING ELECTRONIC SIGHTS

BEFORE MOUNTING A SIGHT, MAKE SURE THE PISTOL IS

COMPLETELY UNLOADED (SECTION 16). ALWAYS KEEP THE

MUZZLE POINTED IN A SAFE DIRECTION AND PLACE THE

“SAFETY” IN THE ON SAFE POSITION. FAILURE TO

FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS

INJURY OR DEATH.

The slide of FNX-4™5 Tactical is modified to accept an optional electronic

red dot sight (electronic sights not included). Two mounting plates are

included to fit Trijicon

or Docter

red dot electronic sights (Figure 32).

Other electronic sights may be installed without a mounting plate. Due

to the variety of electronic sights available we do not offer mounting

hardware for all of them. The mounting hole sizes and threads are 6-32

and 5-40.

21.1. DOCTER

AND TRIJICON

ELECTRONIC SIGHTS

1. Completely unload the pistol as described in Section 16.

2. Disassemble the pistol as described in Section 17.1.

3. Use a T10 TORX

wrench to remove the two screws that hold the slide

cap in place and remove the slide cap (Figure 33).

Docter

Mounting Plate

Trijicon

Mounting Plate

FIGURE 32

Two mounting plates are included.

FIGURE 33

Remove the slide cap.