Manual

5. FIELD STRIPPING

5.1. Disassembly of the carbine

5.1.1. Safety checks and cocking the hammer

• Carry out the safety checks (see § 4.1).

• Pull the charging handle completely rearwards.

After having been pulled, the charging handle will

then move freely to the front.

The hammer is then cocked to allow the removal ofThe hammer is then cocked to allow the removal of

The hammer is then cocked to allow the removal of

the hammer group assembly (see below).the hammer group assembly (see below).

the hammer group assembly (see below).

5.1.2. Barrel receiver

Before any intervention on the FS2000 carbine,

ensure to be familiar with the safety information

given in Chapter 1 of this Owner’s Manual.

• Push the stripping

pin located at the

right side of the

carbine.

The stripping pin will

then go out at the left

side of the carbine.

• Pull the stripping pin at the left side of the carbine until it

goes no further.

• Remove the barrel receiver out of the frame by pushing it

forwards.

WARNING

After firing, the barrel can be hot.

Stripping pin

Frame

Barrel

receiver

WARNING

Wear eye protection and safety shoes when

disassembling and reassembling the carbine

to protect you from any injury.