Manual

40 41
2. Maintain light pressure on the
punch and slide the backstrap
downward, off the grip (Figure 31).
3. Install the desired backstrap by
sliding it up the rail. It will snap
into place.
19.2. ACCESSORY RAIL
The frame of the FNP-45 Tactical
features a rail on which accessories,
such as a laser sight or flashlight,
can be installed. Follow the instructions included with the accessory when
mounting accessories to your pistol.
20. COMBAT SIGHTS
The high profile combat sights are factory set for a combat hold (point of
aim equals point of impact) at 20 yards. This may vary slightly with
different types of ammunition.
Do not try to adjust the sights yourself. Send the pistol to the FNH USA
Product Service Center, your departmental armorer or a qualified gunsmith
for this adjustment.
21. MOUNTING ELECTRONIC SIGHTS
BEFORE MOUNTING A SIGHT, MAKE SURE THE PISTOL IS
COMPLETELY UNLOADED (SECTION 16). ALWAYS KEEP THE
MUZZLE POINTED IN A SAFE DIRECTION AND PLACE THE
“SAFETY” IN THE ON SAFE POSITION. FAILURE TO FOLLOW
THESE WARNINGS COULD RESULT IN SERIOUS INJURY
OR DEATH.
• Always keep the pistol in immaculate condition and good
working order.
• Always clean and lubricate the pistol after use.
• Regularly inspect the pistol, its parts and accessories.
19. ACCESSORIES
19.1. INTERCHANGEABLE BACKSTRAPS
BEFORE CHANGING BACKSTRAPS, MAKE SURE THE PISTOL
IS COMPLETELY UNLOADED (SECTION 16). ALWAYS KEEP
THE MUZZLE POINTED IN A SAFE DIRECTION AND PLACE
THE “SAFETY” IN THE ON SAFE POSITION. FAILURE TO
FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS
INJURY OR DEATH.
In order to optimize grip on the pistol as a function of the ergonomics of the
shooter, four backstraps are supplied (Figure 29). One backstrap is installed
on the pistol at the factory. The backstrap can be replaced as follows:
1. Insert a
1
/ 16" punch or other small instrument into the hole in the
backstrap and gently push inward to release the internal locking tab
(Figure 30).
Backstrap
Frame
FIGURE 31
Slide the backstrap down and off of the frame.
FIGURE 30
Use a small instrument to press the
backstrap retainer.
FIGURE 29
Four accessory backstraps are included.