Manual

42 43
7. Assemble the pistol as described in Section 17.3.
8. Zero the sight according to the sight manufacturers’ instructions.
21.2. C-MORE SYSTEMS
™
STS AND FNH USA SIGHTS
1. Completely unload the pistol as described in Section 16.
2. Disassemble the pistol as described in Section 17.1.
3. Use a T10 TORX
®
wrench to remove the two screws that hold the slide
cap in place and remove the slide cap (Figure 33).
4. Install the sight onto the slide, lining up the holes in the sight with
the holes in the slide (Figure 37). These sights do not require a
mounting plate.
The stainless steel slide of the FNP-45 Tactical is cut to accept an optional
electronic red dot sight (electronic sights not included). Two mounting bases
are included to fit Trijicon
®
or Docter
®
red-dot electronic sights (Figure 32).
To install an electronic sight on the FNP-45 Tactical follow the instructions
beginning on page 42.
21.1. DOCTER
®
AND TRIJICON
®
ELECTRONIC SIGHTS
1. Completely unload the pistol as described in Section 16.
2. Disassemble the pistol as described in Section 17.1.
3. Use a T10 TORX
®
wrench to remove the two screws that hold the slide
cap in place and remove the slide cap (Figure 33).
4. Install the correct mounting plate, lining up the pins on the mounting
plate with the holes in the slide as shown in Figure 34 (Docter
®
) or
Figure 35 (Trijicon
®
).
5. Place the sight onto the mounting plate, lining up the holes in the sight
with the mounting plate pins.
6. Apply a drop of medium-strength threadlocker to the mounting screws
and tighten them with T10 Torx
®
wrench (Docter
®
) or T15 Torx
®
wrench
(Trijicon
®
).
Notice! DO NOT OVERTIGHTEN THE SCREWS.
Docter
®
Mounting Plate
Trijicon
®
Mounting Plate
FIGURE 32
Two mounting plates are included.
FIGURE 34
Docter
®
installation.
FIGURE 33
Remove the slide cap.
FIGURE 35
Trijicon
®
installation.
FIGURE 36
Trijicon
®
sight installed with mounting plate.
FIGURE 37
FNH USA sight installed without mounting plate.