Declaration of Conformity

Table Of Contents

Federal Communications Commission (FCC) Declaration of Conformity

FCC Caution: Any changes or modiﬁcations not expressly approved by the party re-

sponsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-

lowing two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation. This device and its antenna(s) must not be co-located or

operating in conjunction with any other antenna or transmitter. 15.105 Information

to the user. (b) For a Class B digital device or peripheral, the instructions furnished

the user shall include the following or similar statement, placed in a prominent lo-

cation in the text of the manual: Note: This equipment has been tested and found

to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment oﬀ and on, the user is encour-

aged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna. —Increase the separation between

the equipment and receiver. —Connect the equipment into an outlet on a circuit

diﬀerent from that to which the receiver is connected. —Consult the dealer or an

experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncon-

trolled environment. This equipment should be installed and operated with mini-

mum distance 20 cm between the radiator and your body.

Radiation Exposure Statement: This equipment complies with FCC radiation expo-

sure limits set forth for an uncontrolled environment. This transmitter must not be

co-located or operating in conjunction with any other antenna or transmitter. The

availability of some speciﬁc channels and/or operational frequency bands is country

dependent and ﬁrmware programmed at the factory to match the intended destina-

tion. The ﬁrmware setting is not accessible by the end user.

The ﬁnal end product must be labeled in a visible area with t he following: “Con-

tains Transmitter Module 2AATL3161ASL” This radio module must not be installed

to co-locate and operating simultaneously with other r adios in host system,

additional testing and equipment authorization may be required t o operating

simultaneously with other radio.

This LMA have RF shielding and is tested and approved as standalone conﬁguration,

additional evaluation may be required for any system integrated this radio module.

FPC Antenna Type, with the maximum 2dBi indicated.

PAGE 1
Federal Communications Commission (FCC) Declaration of Conformity FCC Caution: Any changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
Integration Instructions for host product manufacturers The following items are submitted in support of application for Modular Transmitter FCC ID as noted above as required by the FCC KDB 996369 D03 OEM Manual v01. These items are provided as integration instructions for host product manufacturers (e.g., OEM instruction manual) to use when integrating a module in a host product. Any requirements that are not applicable to the Module are as indicated below. Summary of requirements and Checklist.