Data Sheet

FCC Statement
FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247
Integral antenna with antenna gain 2dBi
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, usesand can radiate radio frequency energy and, if not installed and
used in accordance with theinstructions, may cause harmful interference to radio communications. However, there is
noguarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference
to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to
try to correct the interference by one or more ofthe following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
If the FCC identification number is not visible when the module is installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the enclosed module. This exterior label
can use wording such as the following: “Contains Transmitter Module FCC ID: 2AATL-6162C-IC Or Contains
FCC ID: 2AATL-6162C-IC”
When the module is installed inside another device, the user manual of the host must contain below warning statements; 1.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
The devices must be installed and used in strict accordance with the manufacturer's instructions as described in the user
documentation that comes with the product.
Any company of the host device which install this modular with modular approval should perform the test of radiated &
conducted emission and spurious emission,etc. according to FCC part 15C : 15.247 and 15.209 &15.207 ,15B Class B
requirement, Only if the test result comply with FCC part 15C : 15.247 and 15.209 &15.207 ,15B Class B
requirement，then the host can be sold legally.