Data Sheet
F89ESSM23
FN-LINK TECHNOLOGY LIMITED
20
FCC/IC Statements
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module. For 15 B
(§15.107 and if applicable §15.109) compliance, the host manufacturer is required to show compliance with 15
while the module is installed and operating.
Furthermore the module should be transmitting and the evaluation should confirm that the module's intentional
emissions (15C) are compliant (fundamental / out-of-band). Finally the integrator has to apply the appropriate
equipment authorization (e.g. Verification) for the new host device per definition in §15.101.
Integrator is reminded to assure that these installation instructions will not be made available to the end-user of
the final host device.
"This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired
operation."
"Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment."
the Integrator will be responsible to satisfy SAR/ RF Exposure requirements, when the module integrated into
the host device.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.
This device licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1)
This device may not cause interference.
(2)
This device must accept any interference, including interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1)
L' appareil ne doit pas produire de brouillage;
(2)
L' appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d' en