Data Sheet

Federal Communications Commission (FCC) Declaration of Conformity
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. (15.247) Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation. This device and its antenna(s) must not be co-located
or operating in conjunction with any other antenna or transmitter.
15.105 Information to the user. (b) For a Class B digital device or peripheral, the
instructions furnished the user shall include the following or similar statement, placed
in a prominent location in the text of the manual:
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator and your body.
Radiation Exposure Statement: This equipment complies with FCC radiation
expo-sure limits set forth for an uncontrolled environment. This transmitter must not
be co-located or operating in conjunction with any other antenna or transmitter. The
availability of some specific channels and/or operational frequency bands is country
dependent and firmware programmed at the factory to match the intended destination.
The firmware setting is not accessible by the end user.
The final end product must be labeled in a visible area with the following: “Contains
Transmitter Module FCC ID: 2AATL-H158A-S” This radio module must not be
installed to co-locate and operating simultaneously with other radios in host system,
additional testing and equipment authorization may be required to operating
simultaneously with other radio.
This Module have RF shielding and is tested and approved as standalone
configuration, additional evaluation may be required for any system integrated this
radio module.