User's Guide

Installing the product
18
1
Remove the film on the back of the RADAR module.
2
Attach the RADAR module’s adhesive surface to
the upper part of the front windshield and press the
adhesive part firmly to secure it.
Before installation, make sure the RADAR
module’s cable length is sufficient and check
the cable routing path.
3
DC-IN
RADAR
V-IN
H D
Connect the RADAR module to the product’s RADAR
connector.
Check the RADAR connector location again
before connecting the module. If you connect
the THINKWARE Connected Dongle to the DC-IN
power connector, the pins inside the port may
be damaged.
4
Turn on the ACC or start the engine to check that the product is powered on. After the product is
powered on, the REC LED and the voice guide are turned on.