Installation Guide

ManualsBrandsFocal Point ManualsBuilding materials3/4 in. x 3-1/2 in. x 96 in. Primed Polyurethane Greek Key Chair Rail Moulding

12 Arentzen Blvd.



Charleroi, PA 15022



800-662-5550



www.focalpointproducts.com

GENERAL PRODUCT INFORMATION

Storage and Handling

• Store polyurethane millwork on a flat, level surface away from extreme heat

• If the millwork is exposed to extreme heat, it should be acclimated to the

installation area’s temperature for 10 to 24 hours

• Repair dents or gashes with wood filler or automotive putty (recommended).

Rejoin broken pieces with PL Premium Polyurethane Construction Adhesive

(or equivalent)

Fastening Guidelines

• Control inevitable expansion and contraction with noncorrosive finish nails or

screws and by applying PL Premium Polyurethane Construction Adhesive at

each connection point and joint

• A power nail gun, adjusted to avoid over-driving the fasteners into the material,

works well with Focal Point products (not to exceed 95 PSI)

Finishing

• For best results, paint Focal Point products with a good quality exterior latex

paint. Focal Point products are factory primed so one coat of finish paint is

typically sufficient

• Focal Point products can also be stained using a “gel” stain or can be

faux finished

• See the Focal Point catalog for prefinished product options

• Remove dirt, grime or other foreign substances from the product surface prior

to painting

Product Application

• Focal Point products are designed to be used for decorative purposes only unless

otherwise noted. (Railing Systems, Columns, etc., do have structural integrity)

• Focal Point products can withstand temperatures up to approximately 140

degrees Fahrenheit. Avoid installation in areas that are subject to solar

temperature buildup

• Focal Point products will withstand exterior elements if properly finished.

Unpainted surfaces will be yellowish in color, and should be patched with

putty, covered with caulk or painted during installation

For specific installation

instructions please visit

www.focalpointproducts.com

Please note: Some Focal Point

window and entry features

may require flashing to prevent

water seepage. (See Window/

Door install instructions for

more details)

Summary of content (3 pages)

PAGE 1
G E N E R A L P R O D U C T I N F O R M AT I O N Storage and Handling For specific installation instructions please visit www.focalpointproducts.com Please note: Some Focal Point window and entry features may require flashing to prevent water seepage.
PAGE 2
M O U L D I N G I N S TA L L AT I O N General • Use only Focal Point DegaBond 948 Adhesive #33333. Please Read And Follow All Installation Instructions Carefully • Focal Point mouldings have the same density and workability as white pine. • Mouldings that have been stored in hot conditions should be allowed to cool down to normal temperatures before installation. • Focal Point mouldings are factory primed. 1. Cutting Bedding Edges • Mark projection and depth on walls and ceilings.
PAGE 3
PA I N T I N G I N S T R U C T I O N S Caution NOTE: A finish coat of paint must be applied to all products or the limited life-time warranty is void. Focal Point polyurethane products ship from the factory with a UV blocking primer paint. If during the course of installation, the original primed surface is damaged or additional exposed areas are created, spackle, sand and touched up the area and re-prime the affected areas with a suitable UV blocker primer.