User Manual

14
ELITE K2 POWER
User manual
2-channel connection Kit (Fig A)
- ES 100K, ES 130K, ES 165K
2-channel connection Kit (Fig B)
- ES 165K2, ES 165KX2
These filters have been designed for use in "bi amplification".
For "conventional" use, with the help of 2 short wires, connect the "input" terminals (IN W+ to IN T+ & IN W- to IN T-)
(Fig C & E)
2-channel Kit connections in the case of bi amplification / BI AMP using (4-channel amp): (Fig F)
- ES 165K2, ES 165KX2
3-channel connection Kit
- ES 165KX3
3-channel Kit connections in the case of bi amplification (Fig K)
- ES 165KX3
These filters have been designed for use in "bi amplification".
For "conventional" use, with the help of 2 short wires, connect the "input" terminals (IN W+ to IN T+ & IN W- to IN
T-) (Fig H & J)
Mounting of the filter
- ES 100K, ES 130K, ES 165K,
- ES 165KX, ES165KX2, ES 165KX3
The filters should be mounted (using the screws provided or with the help of double sided tape), preferably in a dry
and ventilated area.
To open the casing, unclip the cover (ES100/130/165K models) or unscrew the 4 screws (ES165K2/165KX2/165KX3
models) (Fig D & I): Warning: for this filter model please keep the 4 aluminium spacers.
Note: If access to the filters is difficult, please implement the cabling and adjustments prior to final mounting.
Installation of the tweeter (ES100K/130K/165K/165K2 kits)
There are three mounting options
1 - Mounting on the inclined pod: choose the desired tilt according to the selected place. (Fig L1)
Make a hole for the cables and screws, mount the stand with the help of the screws
included in the kit, thread the 2 wires and then mount the tweeter in its housing
(adjusted mounting). These tasks can be performed when the grating is assembled.
Warning: To remove the tweeter from this accessory, please act on the edge and, using a fine-blade tool as a
lever, remove the tweeter/plastic collar/grille assembly.
2 - Mounting in the original place: Remove the grating, disassemble the plastic collar exerting pressure in
order to remove this spare part from the tweeter body, remount the dome protective washer. (Fig L2)
The dome of the tweeter should not enter into contact with a surface or a spare part of the vehicle: Respect the
mounting of this important protective washer; this is required for all mountings without a grating in original places.
3 - Flush mounting: cut out a 40 mm in diameter hole. “Tight” adjustment (Fig L3)
Note: To mount the plastic collar, please respect the guide that ensures sound assembly of the 2 parts.