Owner's Manual

• If you have six input wires from the source deck plug them into inputs 1+2, 3+4, 5+6.

Set INPUT switch to 6.

• Put your woofer/tweeters on channel 1+2, 3+4.

Set 1+2, 3+4 switch to HP.

Adjust 1+2, 3+4 HP frequency to 75 Hz.

• One 4ohm subwoofer bridged mono is wired to channel 5+ and channel 6-.

* Do NOT use a 2ohm subwoofer.

Set channel 5+6 switch to LP/BP.

Set channel 5+6 MODE switch to SUB.

Plug in the remote sub control.

Adjust the 5+6 LP frequency to 75 Hz.

For a sealed box adjust the 5+6 HP frequency to 20 Hz.

For a vented box adjust the 5+6 HP frequency 5 Hz lower than the port tune frequency.

REMOTE SUB CONTROL

+–

SUBWOOFER

75Hz6 HP

75Hz20Hz SUB

LP/BP

75Hz HP

C3 (5 CHANNEL WITH BRIDGED SUBWOOFER)

RADIO

XOVER

XOVER XOVER

TRIAMP A SUBWOOFER, WOOFER, AND TWEETER (SEE GRAPHIC C4 ON PG 5)

• Connect the source deck front channel wires into inputs 1+2.

Set INPUTS switch to 1+2.

• Connect your tweeters to channels 1+2.

Set 1+2 switch to HP.

Adjust 1+2 HP frequency to the tweeter manufactures recommendation. 4 kHz is a good starting point.

• Connect your woofers to channels 3+4.

Set channel 3+4 switch to LP/BP.

Set channel 3+4 switch to BP.

Adjust the 3+4 LP frequency to the manufactures recommendation. 4 kHz is a good starting point.

Adjust 3+4 HP frequency to 75 Hz.

• If you have two subwoofers connect one to channel 5 and one to channel 6.

• If you have one 4ohm subwoofer connect it to channel 5+ and channel 6-. Do NOT use a 2ohm subwoofer.

• Set channel 5+6 switch to LP/BP.

Set channel 5+6 MODE switch to SUB.

Plug in the remote sub control.

Adjust the 5+6 LP frequency to 75 Hz.

For a sealed box adjust the 5+6 HP frequency to 20 Hz.

For a vented box adjust the 5+6 HP frequency 5 Hz lower than the port tune frequency.