User Manual

ALPHA
User Manual
15
Once the position is defined, decouple the
monitors from the stand / desk by positioning
the 4 rubber pads provided (fig. F). The gap and
the right/left positioning of each loudspeaker
permit to control the width, the centering and
the global coherence of the soundstage (left/
center/right), at the source of your recording/
mixing precision.
Surround positioning
In case of 5.1 set up, we recommend you
to position the monitors on a circle to have
the same distance between the sweet spot
(listening position) and every single monitor.
The center monitor should be placed at 0°,
front right monitor at 30°, rear right monitor
at 110°, rear left monitor at 250° and front left
monitor at 330° (fig. H).
30°
110°
250°
330°
Running in
As in all brand new loudspeaker, the drivers need some run-in period: the ALPHA transducers are mechanical
elements demanding a little time to settle and adapt to the climatic environment. This period will vary, depending
on the working conditions and may take up to a few weeks. Avoid pushing the speakers very hard during their first
hours of use, but to accelerate the run-in process, it is good practice to operate the speakers at moderate levels for
20 hours or so, with programs having significant low frequency content. Only once the transducers have come to
stabilize will you get the optimum performance.
Stereo positioning
We highly recommend you to position the monitors to have
an equilateral triangle. The 3 points of the triangle are
composed of the 2 monitors and your listening position
(fig G).
F
G
H