User Manual

ALPHA
User Manual
-8 dB
-7 dB
-6 dB
-5 dB
-4 dB
-3 dB
-2 dB
-1 dB
0 dB
1 dB
2 dB
3 dB
4 dB
5 dB
6 dB
7 dB
8 dB
10 Hz
100 Hz 1000 Hz 10000 Hz
1 - BALANCED
The XLR inlet permits the connection of a source of balanced signal and follows standard wiring instructions.
Pin 1 = ground (shielding)
Pin 2 = In phase voltage (hot)
Pin 3 = Out-of-phase voltage (cold)
The balanced input is already set on +4dBu sensitivity to match the sensitivity of any balanced audio source.
2 - UNBALANCED
The RCA inlet permits the connection of a source of unbalanced signal. It is common to link the out-of-phase voltage
(Pin 3) to the ground (Pin 1). This connection is generally made on the wires. The unbalanced input is already set on
-10dBV sensitivity to match the sensitivity of any unbalanced audio source.
3 - SENSITIVITY
This switch function is to allow more SPL from the monitor if necessary. The available sensitivities are 0dB and
+6dB. We recommend you to set the sensitivity on 0dB. The +6dB is an interesting solution when you want more SPL
whereas your audio source is already reaching its output limit.
4 - ON/OFF
The ON/OFF switch permits to switch the internal amplifiers ON or OFF. When switching on the monitor, the standby
is activated. To unmute the monitor, send audio signal to the monitor which will detect it and will automatically
unmute the monitor.
5 - STANDBY
The standby LED is off when the power switch is off. It is on when powering on the monitor. As soon as the monitor is
detecting an audio signal, the standby is deactivated and the LED is off. After about 30 minutes without audio signal,
the monitor is automatically muted to avoid unecessary power consumption. When muted, the power consumption
is <0,5W. To unmute the monitor, send audio signal to the loudspeaker. The loudspeaker will require few seconds to
unmute.
6 - LF SHELVING
The LF SHELVING potentiometer permits to activate or not a correction of the sound level under 300Hz. We advise
you to set the LF SHELVING potentiometer on +2dB when the premises acoustics naturally soften that frequency
range. We advise you to set the LF SHELVING potentiometer on 0 when the premises acoustics is neutral.
We advise you to set the LF SHELVING potentiometer on -2, -4, or –6dB when the loudspeakers are placed next to
a wall or an angle.
7 - HF SHELVING
The HF SHELVING potentiometer
permits to activate or not a correction
of the sound level from 4.5 kHz. We
advise you to set it on +2dB when
the premises acoustics naturally
softens this frequency range (mat
environment). When the premises
acoustics is neutral, 0dB setting
is recommended. –2 or –3dB are
recommended when the premises
acoustics naturally increases this
frequency range (bright environment).
ALPHA 50, ALPHA 65 and ALPHA 80 controls and connectors
16