Specification Sheet
Separable crossovers
Detachable tweeter and
woofer crossovers for more
flexible installation options
Aluminium basket
Lightweight, tough and stylish
thanks to a ‘rotor’ design
and slate-blue finish
Slatefiber cone
Made from
non-woven,
recycled carbon fibres
Al/Mg tweeter
Aluminium alloy and
magnesium inverted dome
tweeter. Quick and easy to
surface-mount or install in the
original tweeters locations
Key points
• Made in France in the Focal workshops
• High power handling for intensive use
• Little amplification requirements
due to high sensitivity
• Tough design and high quality materials
• Flexible installation options
The 6
1/2
" (16.5cm) 2-way separate Slatefiber kit can be summed up in one word: ecient. This product
incorporates the essence of Focal's latest technologies to deliver performance, reliability and French
manufacturing. With standard dimensions and a smart design, it can be installed in most vehicles on the
market without the need for an additional dedicated amplifier. However, you can still link these speaker
drivers to an amplifier if you want to get the very best performance out of them.
Type 2-way component kit
Woofer
165mm
Depth
70mm
Cone
Slatefiber
Maximum power
160W
Nominal power
80W RMS
Sensitivity (2.83V/1m)
91dB
Frequency response
60Hz - 21kHz
Impedance
4 Ω
Voice-coil diameter
25mm
Magnet
Ferrite
Suspension
Butyl
Tweeter
Aluminium/Magnesium
inverted dome tweeter
Crossover
Independent woofer/tweeter
crossovers
SLATEFIBER
PS 165 SF
Product sheet
Focal
®
is a trademark of Focal-JMLab
®
- www.focal.com - SCCG - 01/02/2022 - v1