User's Manual

4. Turn on the computer to operate the mouse. If the mouse is functional, when the
mouse moves the LED on the receiver will flash.
The Receiver.
(receiver )
RF signal LED(flashes when the mouse is being used).
Trouble shooting.
If you mouse does not work, please try the following:
1. Make sure the cables are connected into the system correctly.
2. The mouse have an optimal range of 2 meter from the receiver. Please keep at
least 20cm of distance between the receiver and other electrical devices(such as
speakers, monitors)
3. Make sure the channels underneath the mouse and the receiver are adjusted to the
same one.
4. Working on metallic surfaces reduces RF performance. Avoid placing receiver
on metallic surfaces.
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.