User Manual

TView Gold User’s Guide
Chapter 2
19
Figure 2-5: Connecting TView Gold to the Television
Note: Because the port may not be labeled, you will need
to match the port to the connector you are using.
Connecting to the Television Using an
RF Modulator
If you do not have a television with composite video or S-
Video, you will need a special adapter called an RF Modulator.
This device converts the Composite Video signal from the
TView Gold unit to an antenna signal. The RF Modulator is not
supplied. FOCUS Enhancements Technical Support
recommends using the Radio Shack RF Modulator (Radio
Shack part number 15-1283).
Note: When using an RF Modulator, the TV may have to
be set to a particular channel (for instance, 3 or 4)
to accept the TView Gold ’s video. Or, in some
cases, you may have to specify input using the TVs
on-screen programming feature. If you are unsure
about how to set your television to accept external
video through the Antenna In, refer to the television
owner’s manual.
To connect the TView Gold to your television using the RF
Modulator, perform the following steps:
1. Connect the RF Modulator to the coaxial input at the rear