Manualshelf

Disk Recorder User Guide FS-2, FS-2E

ManualsBrandsFOCUS Enhancements ManualsCamcorderFS-2E
21222324252627282930
Introduction
FS-2/2E Studio DTE Disk Recorder User Guide
10
1.8.2 Rear Connection Panel
The FS-2/2E rear panel, shown below, contains control and audio/video
input/output areas described in this section.
You can select any of the available inputs as a source. When selected, that
source is what is recorded to disk. If the unit is in E-E mode or recording, all
outputs are live with the incoming signal.
For any particular video input, there is an associated audio input selected as
a default. You can change that default to another input utilizing the
AUDIO
INPUT MENU
under SETUP. Refer to Chapter 2 for more information.
1. GPI - For connection of the optional wired remote control (ACSS-0019-
01), the optional RS232C cable (CBLA-0113-01) or contact closure
cable. The GPI plug accepts a 3.5mm TRS connector.
2. Front Panel HDD Port Loop Through - When patched to the To HDD
port, this connector activates the front panel FireWire port for
connection of external HDDs.
3. RS422 Control - This is the input connector for external RS422 control
devices.
4. SDI Input - For connecting SDI input sources. The FS-2E provides the
selection of channels 1 and 2 or 3 and 4 of the embedded SDI audio.
Refer to the
AUDIO INPUT > SDI > EMBEDDED sub-menu on Audio
Input
on page 59. The FS-2 does not have this capability.
SDI Output - For output to SDI devices. The FS-2E inserts two channels
of audio into the SDI output stream. Only the FS-2E has this capability.
5. Y/C Input - For connecting Y/C (S-Video) input sources.
Y/C Output - For connecting to Y/C (S-Video) devices.
6. Composite / Y Input - For connecting composite input sources or the Y
signal for component input sources.
Composite / Y Output - For output to composite devices or the Y signal
to component devices (select either composite or component form
ANALOG SETTINGS in the SETUP menu).
7. Pb Input - For connecting the Pb signal from component input sources.
Pb Output - For output of the Pb signal to component devices.
1
2
20
3
4 5
6
7
8
16
9
10
11 12 13 14
15
19 18 17