FOCUSER@5566mail.com Model NO.
NOTE GPS Wireless Dog Fence is designed FOR OUTDOOR USE ONLY.
Components Operating Guide Step 1: Charge Receiver Collar(s) The USB Charger is designed to plug into a standard AC wall outlet. 1 2 The Collar Light will remain red flickering when the Receiver Collar(s) is 3 charging properly. “ ” The light will turn red when charging is complete. “ ” Battery Status: The battery power can support device working continuously for 25 hours in the power-on state, and user can press any key to 4 5 6 view the battery status in standby state.
Step 2: Set Up Receiver Collar(s) 1. Press the power key “ will first flickering “ ” for 3 sec to turn on the device. The display ” , then takes 1-3 minutes wait until the display numbers reaches to six or more. Now, it’s ready for next steps. Press for 3 seconds TIPS The “ ” shows signal strength. Please use this system with 2 or Up to 990M in Radius more Frames “ ” or “ ” Poor GPS signal, this area is not suitable for GPS wireless system. “ ” : Fair GPS signal, this area is OK but not perfect.
1m Beep Modes: 0~1. With "1", beep mode ON, with "0" for beep OFF. 1m Virbration Modes: 0~6. With "0", the vibration mode off, and 1-6 modes can be set as the corresponding intensity of vibration that pets can receive. Shock Modes: 0~10. With "0", the shock mode off, and 1-10 modes can be set as the corresponding intensity of shock that pets can receive. TURN ON the collar in the same spot everytime .
1. Follow the step 2 to set up your desired zone. 2. Using the Test Light, hold the Receiver Collar(s) at your pet’s neck height. 3. Walking toward to the edge of the desired zone you set up until the Receiver Collar(s) beeps and the Test Light Flashes. 4. Place a Training Flag in the ground. 5. Walk back into the desired zone until the beeping stops. 6. Repeat this process around the boundary zone until it is marked with Boundary Flags every 10 feet. Test light instructions. 1.
Training Guide Trim the collar as belows: • Mark the desired length of the Collar with a pen. • Remove the Receiver Collar from your pet and cut off the excess. • Seal the edge of the cut collar by applying a flame along the frayed edge. • Have fun with your pet throughout the training process. Training Should be fun, fair, firm and consistent. • Train for 10 to 15 minutes at a time. Don’t try to do too much or too quickly, More-frequent short sessions are better than less-frequent longer sessions.
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
