User Manual

18
Monitor section
The output levels of the monitor outputs and line outputs are configured in the Monitor Section. You can set up your Saffire PRO 14
so that the audio sent to the line outputs are controlled by the software volume dial; independent of the software volume dial; or
muted.
Monitor control enable buttons (1 to 4)
The monitor control enable buttons indicate which outputs are controlled by the monitor section on the GUI directly below the 4
buttons. The Saffire PRO 14 can be set up so that you have control of volume levels, and depending on your monitoring set-up, you
may control the level sent to just a single pair of speakers, or up to 4 speakers simultaneously.
(All digital output levels are unaffected by the monitor section in Saffire MixControl. Use the output levels of the DAW to control
digital output levels).
Each button can be set to 1 of 3 possible states:
Blue - this output is controlled by the below monitor section.
Red - this output is not controlled by the below monitor section and it is muted.
Grey - this output is not controlled by the below monitor section and it is at full level.
To set a button to its grey state, SHIFT + Click the button.
WARNING: When a monitor control button is set to ‘Grey’, the signal routed to that output will be played back at full level.
This may potentially result in a very loud signal being sent to your monitor speakers, headphones or other equipment.
Be cautious when setting your levels (in your DAW or the Saffire MixControl Mixer) before setting the monitor button to Grey.