User Manual
18
Monitor Section
The output levels of the monitor outputs and line outputs are congured in the Monitor Section. You can set up your Safre Pro 24 so
that the hardware ‘Monitor’ knob on front panel of the Safre Pro 24 will control the desired outputs, such as your stereo monitors,
your surround sound system. Alternatively the hardware ‘Monitor’ knob be deactivated for specic outputs e.g. when hardware
volume control is required for a pair of monitor speakers, but not for additional outputs being sent to e.g. an external compressor.
Additional controls such as mute, dim and mono are available.
Monitor control enable buttons (1 to 6)
The monitor control enable buttons indicate which outputs are controlled by the monitor section on the GUI directly below the ten
buttons. The Safre Pro 24 can be set up so that you have hands-on control of volume levels, and depending on your monitoring set-
up, you may control no speakers, just a single pair of speakers, or up to 6 speakers simultaneously.
(All digital output levels are unaffected by the monitor section in Safre Mix Control. Use the output levels of the DAW to control
digital output levels.)
Each button can be set to 1 of 3 possible states:
Blue - this output is controlled by the below monitor section.
Red - this output is not controlled by the below monitor section and it is muted.
Grey - this output is not controlled by the below monitor section and it is at full level.
To set a button to its Grey state, SHIFT + Click the button.
WARNING: When a Monitor control button is set to ‘Grey’, the signal routed to that output will be played back at full level.
This may potentially result in a very loud signal being sent to your monitor speakers, headphones or other equipment.
Be cautious when setting your levels (in your DAW or the Safre Mix Control Mixer) before setting the monitor button to Grey.