User Manual

8
Rear Panel
• AC Mains Inlet. Standard IEC receptacle for connection of AC mains. Red 16Line features a
‘Universal’ PSU, enabling it to operate on any supply voltage between 100 V and 240 V AC.
• Word Clock – Input allows synchronisation to word clock.
• Word Clock – Output provides an output of the chosen system clock reference.
• Loop Sync I/O sockets allow Red 16Line to integrate with a standard Pro Tools system I/O chain.
• Dual Thunderbolt 3 Connection. Two ports allow either direct or chained connection to your
workstation.
• Pro Tools | HD Interface. Two Mini DigiLink Primary connectors; use Mini DigiLink cables to
connect to a Pro Tools | HD HDX PCIe card or Pro Tools | HD Native system.
• Line Outputs on two 25-way DB25 female connectors.
DB25 connectors are wired according to the AES59 Standard (also known as the TASCAM Analogue standard).
• Line Inputs on two 25-way DB25 female connectors.
Note that Line input circuits 1 & 2 can be re-assigned to the Microphone and/or Instrument connectors so may
not always be available on the input connector. See page 10 for further information.
• Microphone Inputs on two XLR-3 female connectors.
• Network. Two RJ45 Ethernet connectors for the Dante network. The connectors form an integral
2-port switch, allowing either to be used on the network.
• ADAT I/O 1 and 2. Two independent 8-channel ADAT optical inputs and outputs using standard
TOSLINK connectors. Optical I/O 1 can also be used in ‘Optical S/PDIF’ mode.
• S/PDIF I/O. 2-channel digital interface on RCA (phono) connectors.
• Monitor Outputs. Balanced 1/4” TRS jacks for connection of Left and Right monitor loudspeakers.
Outputs are at line level so unpowered speakers will require external amplification.
See Appendix 1, page 24 for the connector pinouts.
Thunderbolt 3
Interface
Pro Tools | HD
Interface
Line Inputs
Loop
Sync
Word
Clock
AC Inlet
2 x ADAT
Optical I/O
Dante
Network
S/PDIF
I/O
L/R Monitor
Outputs
Line Outputs
Microphone
Inputs