User Manual

7
INTRODUCTION
Thank you for purchasing the Focusrite RedNet 5/HD32R.
RedNet 5/HD32R is a multichannel, bi-directional Dante interface, which allows an Avid® Pro
Tools|HD system direct access to a Dante digital audio networking system.
Each unit acts as a 64-channel (32 in/32 out) digital break in/out box and both support a wide range of
Pro Tools|HDX and HD cards. Up to six RedNet 5/HD32R modules can be used with a Pro Tools|HDX
system and three with Pro Tools|HD, allowing the maximum channel count for either.
Connection to Pro Tools system is via standard DigiLink [Mini DigiLink] ports.
An additional Avid/Digidesign interface may be connected to the expansion port.
The front panel contains a set of LEDs to confirm network status, sample rate, clock sources and
signal presence on both input and output.
RedNet D16
HD32R
Dual Ethernet connectors (primary and secondary) on the rear-panel allow maximum network
reliability with seamless switchover to a standby network in the unlikely event of a network failure.
These ports may also be used to daisy-chain additional units when operating in Switched mode.
Redundant power supplies (PSU A and B) with separate input sockets on the rear panel allow
one supply to be connected to an uninterruptible source. Each PSU’s status can be monitored
remotely over the network or from the front panel.
RedNet 5
A Mini DigiLink-to-DigiLink adaptor cable is included to allow compatibility with Pro Tools|HDX or
Pro Tools|HD Native systems that use the Mini DigiLink connection.
RedNet 5
RedNet HD32R