User Manual

13
registered your purchase at www.focusrite.com/register. The Product Registration Card provided
with your RedNet unit contains a validation code which you will need to enter in the Registration
area. This procedure ensures that you will have the most up-to-date software versions.
Can’t get started?
If you have any trouble with this product
do not go back to the place of purchase.
Contact our support team on:
US:
UK &
International:
Online:
PLACE SERIAL NUMBER STICKER HERE
1-855-24-FOCUS (1-855-243-6287)
Support available Monday - Friday 8am – 6pm (PST)
[phone]
Support available Monday - Friday 9:30am – 6pm (GMT/BST)
www.focusrite.com/support
www.novationmusic.com/support
FA0736-01
Go to www.focusrite.com/register, and follow the instructions on the card to register your product
and download RedNet Control and associated software.
When all downloads are complete, install the RedNet Control application in the usual manner. Follow
all on-screen instructions from this point.
Audinate Dante Controller
This software application is automatically installed when RedNet Control is installed. RedNet
functions can be controlled from RedNet Control and routings can be be defined in Dante Controller.
Dante Controller can also be downloaded from www.audinate.com. Register first, then download and
install.
Connecting your RedNet audio network
Remove any Ethernet cables connected to your computer (these can be reconnected after setting
up RedNet - either to the Gbit switch, or to any additional vacant Ethernet ports you have on your
computer).
Connect a vacant Ethernet port on your computer to a port on your Gbit Switch with a Cat6 Ethernet
cable. If you have installed a RedNet PCIe/ PCIeR card, connect its Ethernet port to a port on the Gbit
switch with a second Cat 6 Ethernet cable.
Connect the Ethernet ports on the rear of each RedNet I/O interface in the system to further ports on
the Gbit switch with Cat 6 Ethernet cables.
The recommended order of powering the components in a RedNet system is as follows:
• Power up the Gbit switch;
• Power up all RedNet units on the networks one by one (power-on sequence takes approx.
40 s per unit)
• Boot the host computer.
When your computer has booted up, launch RedNet Control.