User's Manual

Spill

Expands a source to show its component channels allowing them to

be muted/un-muted individually:

• Select a source to spill

• Screen 1 will display the (up to) 12 channels contained within

that source:

Use the soft-buttons to mute/un-mute channels.

Muted channels are shown with a red ‘M’

Mode

Selects the ‘Monitors’, ‘Mic Pre’ or ‘Settings’ submenus:

Monitors – Accesses the current speaker/monitor or headphone

selection mode.

Mic Pre – Accesses the hardware controls of a remote device.

• Use soft-buttons 1-4 or 7-10 to select a remote device to control.

Then use:

Buttons 1-3 and 7-9 to control the device parameters

Buttons 5,6,11 & 12 to enable talkback

• ‘Output’ allows the global output level to be adjusted without

having to change mode:

Select soft-button 12 and rotate the Output Encoder to adjust

the global level

Deselect to return to Mic Pre mode

• ‘Gain Preset’ provides six locations where a gain value can

be stored. A stored value can then be applied to the currently

selected channel by pressing the appropriate Preset button

To assign a preset value:

Select a Preset button and rotate the Output Encoder to the

required level

Press-and-hold the button for two seconds to assign a new

value

Press ‘Mic Pre Settings’ to return to the mic parameter display

Continued...

Function Keys . . .