User's Manual

16
Channel Mapping
The Channel Mapping page displays the cross-point grid for each Source Group/Output Destination
selection. Individual cross-points can be selected/deselected or level trimmed.
• The number of rows displayed corresponds to the number of channels in each Source Group
• An Input Source may be routed to multiple Outputs, to assist in the creation of fold-up or Fold-downs
• Each grid cross-point can be trimmed by clicking and entering a value via a keyboard
• The Solo-To-Front loudspeaker can be routed to only one Output Channel
Adding channels (1–12) to the channels already in a source is non-destructive and will not change the routing.
However, if the user changes from a 12 channel Source Group to a 10 channel Source Group, then the mix
coefcients for channels 11 and 12 would be deleted – requiring them to be set up again if those channels were
subsequently reinstated.
Channels Remaining in Mixer
A maximum of 32 channels are available. The number of channels remaining is shown above the
Source Group buttons.
Talkback Channels may be reallocated to allow for additional group channels.