Other Content

In order to use Focusrite Control for iOS to alter the volume to your headphones, it's important to
also have the headphone output dial on the interface itself turned up. You can then make
adjustments to the level using the fader in the iOS app.
Conversely, the headphone outputs on the Red Range are digitally controlled and so can be
adjusted exclusively from the iOS app if required.
The Mac OS X firmware updater keeps failing.
What do I do?
Article applies to: Saffire, Saffire LE.
The firmware update has two stages. You will see a progress bar for each stage. Please check the
colour of the LINE / INSTR LEDs on the front panel. They should be green before the update.
When the firmware update begins, the LEDs will turn to orange in the first stage. When the first
progress bar completes, the LEDs should turn green again before the second stage.
If they stay orange, please disconnect/reconnect the firewire cable (and the external power supply if
in use) and wait until the LEDs turn green.
They will stay green for no more than a few seconds, and then turn orange again for the second
stage of the firmware update. Once the second stage progress bar completes, the LEDs will turn
green again and stay green.
At this point the firmware update should be complete.
My Scarlett is Showing as an Input, but not as an
Output Device on OSX/macOS
Applies to: Scarlett 1st Gen interfaces