Installation Instructions

ManualsBrandsFolger Adam ManualsElectronicsFail Secure Fire Rated Electric Strike in Satin Stainless Steel

Installation Directions

1. Attach the faceplate to the strike body using the

#8-32 Body Mounting screws as illustrated on page 3,

Diagram 2.

2. If using the LCBLCM (Latchbolt & Locking Cam Monitor),

see Diagram 1 for wiring

instructions.

3. The strike body ships as either a 12 or 24 volt

unit and is not field selectable. Verify the available

voltage is +/- 10% of the rated voltage of the strike body.

Prepare Strike

CAUTION! Before connecting any device at the installation site, verify input voltage using a multimeter.

Many power supplies and low voltage transformers operate at higher levels than listed. Any input voltage exceeding

10% of the solenoid rating may cause severe damage to the unit and will void the warranty.

Prepare Frame

Finish Installing

6. Connect the Plug In Connector to the electric strike, and

connect wires from the Plug In Connector leads to the

power source.

7. Install the electric strike unit in jamb cutout, using the

#12-24 x 1/2” faceplate mounting screws for metal

applications, or #12 x 2-1/2: wood screws for wood

applications.

5. Prepare frame using the template for your strike

located on pages 4-6. If using the 742-75, see the 742-75

template on page 3 to install the Deadlatch Tab and

Keeper Shim. Note: Drawing shows only one shim.

Latchbolt Monitor (LBM)

White

Orange

Normally Open

Green

Normally Closed

Common

Locking Cam Monitor (LCM)

Brown

Blue

Normally Open

Yellow