SDS

M A T E R I A L S A F E T Y D A T A S H E E T
Date Printed: 01/14/08
3
HANDLING: Avoid employee exposure through the use of appropriate engineering controls,
adequate personal protective equipment, and good industrial hygiene practices. Wash
thoroughly after handling. Handle in well-ventilated workspace.
STORAGE: Store in a moderate cool, dry, well ventilated area away from direct sources of
heat. Avoid freezing (32F). Position containers so that any labeling information is visible.
Keep containers closed.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS: The use of local exhaust ventilation is recommended to
control emissions near the source. Additional engineering controls should be used as
necessary.
RESPIRATORY PROTECTION: Respiratory protection is generally not required. A
respiratory protection program meeting OSHA 1910.134 and ANSI Z88.2 requirements must
be followed whenever workplace conditions warrant a respirator's use.
SKIN PROTECTION: Impervious clothing should be worn when gross contact is likely, such
as when cleaning up large spills. Neoprene gloves may provide protection against permeation.
EYE PROTECTION: Use safety glasses with side shields (ANSI Z87.1 or approved
equivalent).
9. PHYSICAL AND CHEMICAL PROPERTIES
BOILING POINT: 212 Deg. F
MELTING POINT: Not determined.
VAPOR PRESSURE: Not Determined
VAPOR DENSITY: Not Determined.
SOLUBILITY IN WATER: 100% Soluble or dispersible.
SPECIFIC GRAVITY: 1.21
PH: 8.5 to 9.5
ODOR: Slight odor of ammonia.
APPEARANCE: Colored dispersion.
COATING VOC: .33 lb/gl
MATERIAL VOC: .05 lb/gl
10. STABILITY AND REACTIVITY